tilt non zero after zfocus
Added by Bob Grassucci over 2 years ago
We are experiencing non zero tilts 1.5 degrees more or less sometimes after a z focus round in MSI-T2. The stage is not reset to zero. While this is not a big deal it is something that would be nice to address. Is this happening elsewhere and can it be resolved by Leginon or is the user forced to reset manually? Thank you.
Bob
Replies (3)
RE: tilt non zero after zfocus - Added by Bob Grassucci over 2 years ago
I see that this was an issue https://emg.nysbc.org/boards/6/topics/2514?r=2515#message-2515
When we reset the stage manually it comes back to zero as requested. Should pyscope be altered as suggested?
Bob
RE: tilt non zero after zfocus - Added by Anchi Cheng over 2 years ago
The reason of the problem, depends on whether your observation happens as a jump or as a gradual deviation from the original.
If the latter, the solution we use is to active tilt like parent image in Hole node. This resets the stage when there is stage drifting on the same direction on the same requested value.
If the former, it would be a bug in specific condition. I am not aware of this happening in high frequency. Please show me the log around the log and more details to debug
RE: tilt non zero after zfocus - Added by Bob Grassucci over 2 years ago
I believe it is the latter of a slow drift. We will set the hole node as suggested. Thank you.
Bob