Hitachi install » History » Revision 6
Revision 5 (Anchi Cheng, 11/19/2020 03:16 PM) → Revision 6/10 (Anchi Cheng, 11/19/2020 03:16 PM)
h1. Hitachi 7800 specific installation h2. Install myami package on the associated camera computer * Instead of installing myami package on HHT scope-controlling PC, the access can be through the computer controlling the digital camera. * No special supporting package needed. h2.hht.cfg hht.cfg records some instrument specific parameters that are required to convert the instrument output to SI units that Leginon depends on. The values in pyscope/jeol.cfg.template is based on NYSBC HT7800 equipped with TVIPS XF416. You may start with these and copy it to pyscope/hht.cfg or other [[locate global config directory on Windows|valid myami configuration file locations]]. h2. instruments.cfg [scope] class: hitachi.HT7800 cs: 3e-3 * Cs for HR and HC modes are 3.0 mm and 5.2 mm, respectively. You will most likely use HR mode on the final image. [scope] class: hitachi.HT7800 cs: 3e-3 * You will also be adding the camera in the same instruments.cfg since this file is located on the camera computer in this instruction. h2. Testing with pyscope In python command <pre> from pyscope import hitachi t =hitachi.HT7800() t.getHighTension() </pre> You should get the current gun high tension value in Volts.