Leginon

h1. Restarting procedure to continue data acquisition

#  main> restart Leginon by 'start-leginon.py'

 

#  Leginon Setup Wizard> Select user and returning sesson and "Start" the program.

 

#  Leginon/Application> select the application used to run. Select the scope and the main launcher, and then launch the application.

 

#  If a simple application such as "Manual" is used, just continue what you were doing.

 

#  If some "MSI" application is used and Leginon did not crash during queue processing, do the following to continue:

 

**  Leginon/Square Targeting/Toolbar/Tiles!http://emg.nysbc.org/software/leginon/images/icons/tiles.png!> select the current mosaic from the pull-down list by checking the ID and label, and then "Load" it.

 

**  Leginon/Square Targeting/Toolbar> "Submit" !http://emg.nysbc.org/software/leginon/images/icons/play.png! the target list that is loaded with the atlas. Leginon will check the status of the target acquisition and processing and pick it up from where it was left off.

 

#  If some "MSI" application is used and Leginon crash during queue processing, do the following at the node where the targets from its queue you wish to continue process.

 

Leginon/XXX Targeting/Toolbar> click on the "Submit the queued target" !http://emg.nysbc.org/software/leginon/images/icons/send_queue_out.png!.

h2.  None of the above will resume data collection if all targets are done or abort by the user. Select new ones on the atlas for more data collection.

______

[[Aborting targets that are not yet being processed |< Aborting targets that are not yet being processed]] | [[General operation problems|General operation problems >]]

______