Restarting procedure to continue data acquisition » History » Revision 5
Revision 4 (Anchi Cheng, 11/28/2012 03:37 PM) → Revision 5/6 (Anchi Cheng, 11/28/2012 03:37 PM)
h1. Restarting procedure to continue data acquisition # main> restart Leginon by 'start-leginon.py' # Leginon Setup Wizard> Select user and returning sesson and "Start" the program. # Leginon/Application> select the application used to run. Select the scope and the main launcher, and then launch the application. # If a simple application such as "Manual" is used, just continue what you were doing. # If some "MSI" application is used and Leginon did not crash during queue processing, do the following to continue: ** Leginon/Square Targeting/Toolbar/Tiles!http://emg.nysbc.org/software/leginon/images/icons/tiles.png!> select the current mosaic from the pull-down list by checking the ID and label, and then "Load" it. ** Leginon/Square Targeting/Toolbar> "Submit" !http://emg.nysbc.org/software/leginon/images/icons/play.png! the target list that is loaded with the atlas. Leginon will check the status of the target acquisition and processing and pick it up from where it was left off. # If some "MSI" application is used and Leginon crash during queue processing, do the following at the node where the targets from its queue you wish to continue process. Leginon/XXX Targeting/Toolbar> click on the "Submit the queued target" !http://emg.nysbc.org/software/leginon/images/icons/send_queue_out.png!. h2. None of the above will resume data collection if all targets are done or abort by the user. Select new ones on the atlas for more data collection. ______ [[Aborting targets that are not yet being processed processed]] |< Aborting targets that are not yet being processed]] | [[General operation problems|General operation problems >]] ______