Actions
Feature #8178
closedAngled and non-square target area display in Leginon target finder
Start date:
10/17/2019
Due date:
% Done:
0%
Estimated time:
Deliverable:
Description
This is especially useful for K3 and DE20
Updated by Anchi Cheng about 5 years ago
- Related to Bug #8027: Feature request: better support for non-square cameras added
Updated by Anchi Cheng almost 5 years ago
- Tracker changed from Bug to Feature
- Subject changed from Target area for non-square camera is still square to Angled and non-square target area display in Leginon target finder
- Description updated (diff)
- Status changed from New to Closed
- Affected Version deleted (
Appion/Leginon 3.4) - Show in known bugs deleted (
No)
Transfer the original description here
For the K3, the target area shown is always drawn as a square, even though the camera is rectangular. This makes hole targeting difficult, since we want to target non-overlapping hole targets. For the orientation on the K3 camera on the Arctica, the x-dimension is correct but the y dimension is too large. I tried looking at the code last night but it was hard to figure out where these squares are drawn
Tested. This uses stage position calibration. If it appears wrong, check the calibrations.
Updated by Anchi Cheng almost 5 years ago
- Assignee set to Anchi Cheng
- Target version set to Appion/Leginon 3.5
Actions