Instrumentscfg for 22 » History » Revision 5
Revision 4 (Jim Pulokas, 06/06/2012 10:17 AM) → Revision 5/17 (Anchi Cheng, 09/18/2013 02:42 PM)
*cs is the coefficient of spherical aberration in meters*. Find out from TEM manufacture the proper value for your tem. *zplane is a number that gives the order of camera*. If a camera with low zplane value is going to acquire an image, Leginon will attempt to retract all camera at higher zplane values. * One computer for both tem and digital camera: <pre> [tem] class: tecnai.Tecnai cs: 2.0e-3 [camera] class: gatan.Gatan zplane: 50 </pre> * Separate Sperate computers for the two instruments: configure only the instrument reside on the particular computer ** On the computer that controls the tem: <pre> [tem] class: tecnai.Tecnai cs: 2.0e-3 </pre> ** On the computer that controls the digital camera: <pre> [camera] class: gatan.Gatan zplane: 50 </pre> * Two camera that retract/insert at controlled by the same time, typically one of them is an off-axis camera, computer and server such as in the case of DE12 and DE Survey camera pair. that retract/insert at the same time. ** On the computer that controls the digital camera: <pre> [camera1] class: de.DE12 zplane: 50 [camera2] class: de.DESurvey zplane: 50 </pre> * Two camera is controlled by the same computer and server but one is retractable and one is non-retractable and at lower position. ** On the computer that controls the digital camera: <pre> [camera1] class: de.DE12 zplane: 50 [camera2] class: tietz.TietzPXL zplane: 5 </pre> * Gatan Orius camera that is installed typically with Gatan K2/Falcon camera is technically on the same plane but is not capable of insertion unless K2 is retracted. On the other hand, K2 camera insertion includes a retraction of Orius at lower level of the function call in DM. Therefore, Orius is considered as a camera at lower zplane. <pre> [camera1] class: dmsem.GatanK2Base zplane: 50 [camera2] class: dmsem.GatanOrius zplane: 49 </pre>