Actions
Instrumentscfg for 22 » History » Revision 2
« Previous |
Revision 2/17
(diff)
| Next »
Anchi Cheng, 06/05/2012 01:47 PM
cs is the coefficient of spherical aberration in meters. Find out from TEM manufacture the proper value for your tem.
zplane is a number that gives the order of camera. If a camera with low zplane value is going to acquire an image, Leginon will attempt to retract all camera at higher zplane values.
- One computer for both tem and digital camera:
[tem] class: tecnai.Tecnai cs: 2.0e-3 [camera] class: gatan.Gatan zplane: 50
- Sperate computers for the two instruments: configure only the instrument reside on the particular computer
- On the computer that controls the tem:
[tem] class: tecnai.Tecnai cs: 2.0e-3
- On the computer that controls the digital camera:
[camera] class: gatan.Gatan zplane: 50
- On the computer that controls the tem:
- Two camera controlled by the same computer and server such as in the case of DE12 and DE Survey camera that retract/insert at the same time.
- On the computer that controls the digital camera:
[camera1] class: de12.DE12 zplane: 50 [camera1] class: de12.DESurvey zplane: 50
- On the computer that controls the digital camera:
- Two camera is controlled by the same computer and server but one is retractable and one is non-retractable and at lower position.
- On the computer that controls the digital camera:
[camera1] class: de12.DE12 zplane: 50 [camera2] class: tietz.TietzPXL zplane: 5
- On the computer that controls the digital camera:
Updated by Anchi Cheng over 12 years ago · 2 revisions