Leginon

*cs is the coefficient of spherical aberration in meters*.  Find out from TEM manufacture the proper value for your tem.

*zplane is a number that gives the order of camera*.  If a camera with low zplane value is going to acquire an image, Leginon will attempt to retract all camera at higher zplane values.

* One computer for both tem and digital camera:

<pre>

[tem]

class: tecnai.Tecnai

cs: 2.0e-3

[camera]

class: gatan.Gatan

zplane: 50

</pre>

* Sperate computers for the two instruments:  configure only the instrument reside on the particular computer

** On the computer that controls the tem:

<pre>

[tem]

class: tecnai.Tecnai

cs: 2.0e-3

</pre>

** On the computer that controls the digital camera:

<pre>

[camera]

class: gatan.Gatan

zplane: 50

</pre>

* Two camera controlled by the same computer and server such as in the case of DE12 and DE Survey camera that retract/insert at the same time.

** On the computer that controls the digital camera:

<pre>

[camera1]

class: de12.DE12

zplane: 50

[camera1]

class: de12.DESurvey

zplane: 50

</pre>

* Two camera is controlled by the same computer and server but one is retractable and one is non-retractable and at lower position.

** On the computer that controls the digital camera:

<pre>

[camera1]

class: de12.DE12

zplane: 50

[camera2]

class: tietz.TietzPXL

zplane: 5

</pre>