Actions
Trimer processing workflow » History » Revision 4
« Previous |
Revision 4/17
(diff)
| Next »
Dmitry Lyumkis, 06/24/2013 09:48 PM
Trimer processing workflow¶
reconstruct an ab initio model using common lines¶
- select a set of ~20 good class averages in the image viewer, and upload them as a template stack (call it, e.g. "ts_initial_models")
- select as many of the class averages that have reliable features which you think are real and correspond to the Fab-bound complex (could be 50, could be 100, etc …), and upload that as another template stack (call it, e.g. "ts_refinement")
- You can access the common lines method under the menu "ab initio reconstruction" and "automated common lines" in Appion. Go there.
- Under "iterative model creation" select the first template stack, "ts_initial_models"
- Under "refinement of aligned and clustered model" select the second template stack, "ts_refinement"
- keep all parameters as default, and try EMAN for iterative model creation. Then fill out the number of images per volume. This should be ~50% of the number of images in the "ts_2g12_initial_models" stack. If you have, e.g. 30 images, this value should be ~15. You can also try IMAGIC for iterative model creation by switching between the two options.
- Fill out the bottom radii for the particles and give a mass. For example, for 2g12, these should probably be: "radius of mask"=200 ; "inner alignment radius" = 0 ; "outer alignment radius" = 140 ; "particle mass" = 750
- Launch the job
- repeat 1-8 with an identical job, EXCEPT that uncheck "iteratively align class averages to each other", and give the run a different name (for example, you can have two runs, titled "acl1" and "acl1_noiteralign" …).
Updated by Dmitry Lyumkis over 11 years ago · 4 revisions